IBM TotalStorage DS300 Best Practices Manual page 589

Hide thumbs Also See for TotalStorage DS300:

Table of Contents

Month may be a number, an abbreviated name of 3 characters, or the full

Year must consist of 2 characters.

If you use numbers for both the day and the month, a day number greater than 12

is an error. If you use a format that is unambiguous (that is, uses the name of the

month rather than a number representing that month), you can express the date

in any order (day/month/year, month/day/year).

Time is expressed as 00:00:00 (hours:minutes:seconds). The seconds field is

Note: If a time is given with no seconds then 0 seconds is assumed.

Time may be supplied either before or after the date, separated from it by a

single '@ ' character, as shown in this example:

06:00:00@25/07/04

Note: If a date is given without a time, the time is assumed to be 00:00:00. If a

time is given without a date then the current date is assumed. If a time is given

with no seconds then 0 seconds is assumed.

The number of bytes may be an integer or a real number followed by a multiplier

letter (case is ignored) to multiply the given number by powers of 1024. The

multipliers are:

A network node that can be defined using either its IP address or host name. If a

host name is used, it is resolved to its IP address to ensure that the name is

An IP number and a netmask. This parameter can take two forms:

Appendix A. Command line interface reference

Totalstorage ds400