IBM TotalStorage DS300 Best Practices Manual page 163

initiator manage
WOLGA-SLOT3-(0)
add WOLGA-BOOT 0
initiator manage
WOLGA-SLOT3-(0)
add WOLGA-DB 1
initiator manage
WOLGA-SLOT3-(0)
add WOLGA-LOG 2
initiator manage
WOLGA-SLOT3-(0)
add WOLGA-MEDIA
3
Figure 4-111 Assigned logical drives to initiators
initiator manage
WOLGA-SLOT4-(1)
add WOLGA-BOOT 0
28.When the order of assigning the logical drives to multiple initiators is not the
same, a warning is shown after clicking Next. Usually there is no need to
initiator manage
assign the same logical drive to more than one initiator. This only makes
WOLGA-SLOT4-(1)
sense when multiple host bus adapters are installed in a server, or cluster
add WOLGA-DB 1
nodes are attached to the TotalStorage DS300 or DS400. The logical drives
initiator manage
need to be removed from the initiators and assigned in the same order to all
WOLGA-SLOT4-(1)
initiators. See Figure 4-112.
add WOLGA-LOG 2
initiator manage
WOLGA-SLOT4-(1)
add WOLGA-MEDIA
3
Figure 4-112 Warning about different LUN IDs assigned to multiple initiators
29.Verify setup and click Apply. In case something is not as desired, use the
Back button and correct the configuration. The two drives which are not
assigned to an initiator are not accessible by a host, and a message indicates
this. See Figure 4-113 on page 146. Click Apply.
Chapter 4. TotalStorage DS300 and DS400 management
145