Network Commands - IBM TotalStorage DS300 Best Practices Manual

rename logical
Enter a new name for this logical drive.
A.23 Network commands
These commands control aspects of the unit's identity on the network. They are
available after the network command has been typed. They can also be run as
global commands by preceding them with network.
Command
dns
domain
gateway
hostname
info
ntp
sanname
smtp
dns ip_list | clear
Define a new list of DNS servers where ip_list is a list of up to three IP numbers
of name servers to use. It replaces the previous list. If a disable value is given
instead of IP numbers, the list of DNS servers is cleared.
domain name
Set the DNS domain name to be name.
This command may be combined with the hostname command on the same line
to configure the network details in one command. The order of the commands
does not matter.
gateway ip_host | clear
Set the gateway network node (or default route) for the unit.
The parameter may be the name or IP number of a router to use as the default
gateway or a disable value if there is no default gateway.
Parameters
ip_list | clear
name
ip_host | clear
name
ip_host | clear
name
host host port port | clear
Appendix A. Command line interface reference
Levels
administrator
administrator
administrator
administrator
all
administrator
administrator
administrator
607