Figure 7-185 SANsurfer — iSCSI target portal
25.Enter the configuration password and click OK.
Figure 7-186 SANsurfer — Security check
26.The Configuration of the HBA will be refreshed by the SANsurfer utility. Click
Yes to accept the refresh.
Figure 7-187 SANsurfer — iSCSI configuration change
27.The configured logical drive ELBE-Quorum was found but session is failed
because no CHAP password was specified to access this iSCSI target. Click
Configure Authentication to add the required authentication settings. Note
Chapter 7. TotalStorage DS300 installation
343