Operator Command; Password Operator | Administrator Command - IBM TotalStorage DS300 Best Practices Manual

hostname name
Set the host name of this unit. When added to the domain it gives the fully
qualified network name.
This command may be combined with the domain command on the same line to
configure the network details in one command. The order of the commands does
not matter.
info
Do a dump of all network information.
ntp ip_host | clear
Set the NTP server to be ip_host. For no NTP server a valid disable value should
be given. If the ip_host name is a valid string for a disable value enclose the
ip_host string in "" characters.
sanname name
Set the name of the Storage Area Network.
This command may be combined with the domain command on the same line to
configure the network details in one command. The order of the commands does
not matter.
host host port port | clear
Set the SMTP server to use. Optionally, the port can be specified. If the port is
not specified, the value is not changed; if the port is given as 0, the default port
number of 25 is used.
If a disable value is supplied instead of a host, the SMTP server name will be
cleared.
A.24 Operator command
Use this command to go from the current level to operator level. If a password
has been defined for operator level, enter it when prompted.
A.25 Password operator | administrator command
Use this command to define a new password to enter the operator or
administrator level, or remove the password requirement.
608
IBM TotalStorage DS300 and DS400 Best Practices Guide