Radius Commands; Debug Radius; Ip Radius Source-Interface - Dell Force10 S4810P Reference Manual

Related
password
Commands
show running-config

RADIUS Commands

The following RADIUS commands are supported by FTOS.

debug radius

View RADIUS transactions to assist with troubleshooting.
C-Series, E-Series, S-Series, Z-Series, S4810
Syntax debug radius
To disable debugging of RADIUS, use the no debug radius command.
Defaults Disabled.
Command Modes EXEC Privilege
Command History
Version 8.3.11.1
Version 8.3.7.0
Version 7.6.1.0
Version 7.5.1.0
pre-Version
6.2.1.0

ip radius source-interface

Specify an interface's IP address as the source IP address for RADIUS connections.
C-Series, E-Series, S-Series, Z-Series, S4810
Syntax ip radius source-interface interface
To delete a source interface, use the no ip radius source-interface command.
Parameters
interface
1424
– specifies a password for users on terminal lines.
– views the current configuration.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the S-Series.
Introduced on the C-Series.
Introduced on the E-Series.
Enter the following keywords and slot/port or number information:
• For a 100/1000 Ethernet interface, enter the keyword
GigabitEthernet followed by the slot/port information.
• For a Gigabit Ethernet interface, enter the keyword
GigabitEthernet followed by the slot/port information.
• For Loopback interfaces, enter the keyword loopback
followed by a number from zero (0) to 16838.
• For the Null interface, enter the keywords null 0.