Inspection Of Forward (A) Gear - TOHATSU MX 50D2 Service Manual

Lower Unit
WX50 only
4
4 Roller Bearing
Do not reuse.
MWX50 only
2
1 Needle Bearing
Do not reuse.
6-62
9.5mm
2
1
GEAR GEAR
GEAR
5
1
GEAR GEAR
GEAR
MWX50 only
Remove roller bearing 4.
2.
Drive out roller bearing from the gear by using a bladed
screw driver or a punch and a hammer at teeth side of the
gear.
· When removing roller bearing, take care
not to scratch forward (A) gear bearing
face.
· Do not reuse removed roller bearing.

26) Inspection of Forward (A) Gear

1. Check forward (A) gear teeth and clutch claws for crack,
damage and wear.
Replace if necessary.
27) Assembly of Forward (A) Gear Parts
When gear case, forward (A) gear or
bearing is replaced, measure backlash and
attach a proper shim.
Refer to "Chapter 6 Shim Adjustment".
MWX50 only
Install roller bearing 1.
1.
Apply gear oil to press-fit face when press-fitting roller
bearing.
When press-fitting roller bearing, face the
marking side to tool side.
Apply gear oil to press-fit face when press-fitting
roller bearing.
GEAR
GEAR GEAR
CAUTION
CAUTION
CAUTION
2st 50D2 2011
GB