Assembling Clamp Bracket - TOHATSU MX 50D2 Service Manual

Bracket
OBM OBM
OBM
5 5
7-48
OBM OBM
OBM
2 2
1 1
3 3
4 4

14) Assembling Clamp Bracket

1. Apply grease to swivel bracket, swivel bracket shaft,
bushing.
2. Put bushing to swivel bracket, and then, insert swivel
bracket shaft 1 into clamp bracket 2 and tilt assistant
spring 3.
Set the tilt stop lever to "Release" position, then
install swivel bracket shaft and assistant spring.
*Tilt assistant spring 3 is discontinuing products for after January in 2012.
Install tilt assistant shaft 4 and bushing 5. And then,
3.
tighten nylon nut to the specified torque.
Nylon Nut 5 :
25 N · m (18 lb · ft) [2.5 kgf · m]
GB
2st X50D2 2011