Inspection Of Drive Shaft; Removing Forward (A) Gear - TOHATSU MFS 9.9 Owner's Manual

22) Inspection of Drive Shaft

1. Check drive shaft for bend and wear. Replace if necessary.
2. Measure drive shaft runout.
Runout Limit : 0.5 mm（0.020 in）

23) Removing Forward (A) Gear

Use commercially available bearing puller 1 to remove
1.
forward (A) gear from gear case.
2. Use universal puller plate to make gap between ball bearing
and forward gear.
3. Put two bladed screw drivers in the gap and pry out forward
(A) gear from bearing.
· Before removing, check bearing for play or
deflection. Replace if necessary.
4st 9.9/15/20 2008
a
a Support point
a
6
6-17