Removing Drive Shaft Housing - TOHATSU MX 50D2 Service Manual

Bracket
1 1
2 2
4 4
7-26

5) Removing Drive Shaft Housing

Use the following steps to remove drive shaft housing.
1. Loosen and remove upper rubber mount cap installation
bolts to remove mount cap 1.
2. Loosen and remove upper rubber mount installation bolts
to remove rubber mount 2.
3. Loosen and remove lower rubber mount cap installation
bolts to remove mount cap 3.
3 3
4. Loosen lower rubber mount installation bolt and remove
the nut.
Drive shaft housing drops if mount bolt is
removed in this step.
Pull out lower rubber mount bolt 4 while holding drive
5.
shaft housing at its top and bottom securely, and remove
drive shaft housing.
Loosen right and left rubber mount installation
bolts in several steps alternately and equally.
CAUTION
· Fully tilt down outboard motor when loosening
mount bolt.
· Remove only the nut and do not remove mount
bolt.
GB
2st X50D2 2011 2st X50D2 2011