Inspection Of Recoil Starter; Assembling Of Recoil Starter - TOHATSU MX 50D2 Service Manual

Power Unit
LIT
LIT
1 1
a a
b b
1 1
5-98
1
LIT
LIT
a a
b b

34) Inspection of Recoil Starter

1. Check ratchet, starter lock and all springs. Replace if any
deformation, wear or damage is found.
2. Check reel and starter case. Replace if any crack or
damage is found.
3. Check starter rope. Replace if any wear, unraveling or
damage is found.

35) Assembling of Recoil Starter

Reverse disassembly procedure to assemble by taking
care of the following matters.
●Apply grease to parts as shown enough.
●When setting new starter spring 1 into starter case, face
starter spring outer edge hook a to the right and set it into
round projection b of starter case.
Since newly delivered starter spring is bound by wire, cut
the wire to release the tension after setting outer end hook
in the case.
●When reinstalling starter spring 1 as same into starter
case, face starter spring outer edge hook a to the right
and set it into round projection b of starter case.
Turn starter case and hold by hand to prevent the starter
spring pop out, then attach starter spring.
GB
2st X50D2 2011