TOHATSU MX 50D2 Service Manual page 320

Lower Unit
8
7
4 Oil Seal
Do not reuse.
6 Roller Bearing
Do not reuse.
MX50
Roller Bearing Attachment 7 :
P/N. 3MC-99710-0
Driver Rod 8 :
P/N. 3AC-99702-0
MX50
Needle Bearing Puller Kit :
P/N. 3C8-72700-0
6-40
Use a press to remove oil seal 4 and roller bearing 6 at
5.
the same time.
6
4
MWX50
This work can be done also by using the following tool
kit.
MWX50
6. When removing only oil seal, use bladed screw driver to
pry apart.
· Before removing, check bearing for play or
deflection. Replace if necessary.
· Direct the side of attachment without O-ring to
roller bearing.
Roller Bearing Attachment 7 :
P/N. 3LC-99710-0
Driver Rod 8 :
P/N. 3AC-99702-0
Needle Bearing Puller Kit :
P/N. 3B7-72700-0
Be careful not to give flaw to propeller shaft
housing when removing oil seal.
GB
2st 50D2 2011