Installation Of Lower Unit - TOHATSU MX 50D2 Service Manual

Lower Unit
2
1
6-100
3
1
TEF
TEF
OBM OBM
OBM
Select washer 1 thickness so that the play is within the
3.
specified range.
Specified Value of Play :
0.2 - 0.4 mm (0.0078 - 0.0157 in)
Type of Washers :
3.0 mm (0.118 in) P/N. 353-64032-0
2.75 mm (0.1083 in) P/N. 353-64034-0
2.5 mm (0.0984 in) P/N. 353-64035-0
Replace washer 1 between propeller shaft 2 and reverse
4.
(C) gear 3 if necessary.
For removal or installation of propeller shaft
housing, refer to;
"Removing Propeller Shaft" and "Assembling
Lower Unit Parts" in Chapter 6.
Play of propeller shaft in forward-reverse direction
out of the specified range can cause revolution of
propeller even in neutral gear while engine is
operating.

38) Installation of Lower Unit

1. Tilt-up outboard motor and lock with tilt stopper.
Set shift rod 1 to up position.
2.
· Apply thin coat of OBM grease to spline of drive
shaft before assembling.
· Apply thin coat of OBM grease to water pipe seal
rubber.
· Lower unit installation can be made easier with
the outboard motor tilted up.
· When installing the lower unit, insert water pipe
into seal rubber properly.
TEF
TEF
OBM
OBM OBM
CAUTION
2st 50D2 2011
GB