TOHATSU MX 50D2 Service Manual page 116

Maintenance
1
2
1
Do not reuse.
5
3
6
3-12
Flushing using drive cleaner (Commercially Available Item)
1.
2.
3.
4.
Inspection of Water Pump
1.
1
6
2.
4
Put drive cleaner 1 on the gear case from the front so
that the drive cleaner covers cooling water inlet as shown.
Put water hose to drive cleaner and run water.
Adjust water flow so that water leaks from driver
cleaner a little.
Set shift lever to neutral (N) and start engine.
Check that cooling water check port discharges water, and
run engine for 3 to 5 minutes at idle speed.
Remove the following part.
Drive out spring pin 1 by using spring pin tool 2.
Spring Pin Tool A 2:
P/N. 345-72227-0 (ø3.0)
● Remove gear case ass'y from drive shaft housing.
Remove the following parts.
3 Gear Case Plate
4 Bolts : M8 4 pcs. (MX50D2 : M8 6 pcs.)
5 Bolts : M10 2 pcs.
6 Gear Case Ass'y (Pull downward to remove.)
GB
2st X50D2 2011