TOHATSU MX 50D2 Service Manual page 408

Bracket
3 3
4 4
8 8
9 9
0 0
7-22
7 7
6 6 5 5
0 0
Install throttle shaft 3 with cable to Tiller handle. Be
3.
careful of location of throttle friction 4, throttle shaft
spacer 5, throttle shaft damper 6 and bushing 7.
1342
Attach Tiller handle ass'y to steering bracket 8, and
4.
tighten nut 9 to specified torque.
Arrange throttle cable as shown.
Tiller Handle Bolt 9 :
6 N · m (4 lb · ft) [0.6 kgf · m]
OBM
OBM OBM OBM
Install advancer arm and adjust position of lock nuts 0 of
5.
throttle cable.
6. Adjust position of lock nuts of throttle cable so that throttle
grip can reach full open and full close positions.
· Adjust cable tension so that it moves
approximately 1mm when pushed lightly with a
finger.
· For more detail, "Adjustment of Throttle Cable"
in chapter 3.
GB
2st X50D2 2011 2st X50D2 2011