Disassembling Clamp Bracket - TOHATSU MX 50D2 Service Manual

Bracket
2 2 2
7-46

13) Disassembling Clamp Bracket

1 1 1
1.
2.
3.
4.
WARNING
· When disassembling clamp bracket, be
sure to fully tilt up outboard motor. If
outboard motor is fully tilt down it can
pop out spring suddenly and result in
severe injury.
· When tilting up outboard motor without
power unit installed, be careful to
operate tilt lock lever to prevent swivel
bracket rise up easy.
Remove drive shaft housing, steering shaft, thrust rod and
copilot before beginning this procedure.
Loosen nut 2 of swivel bracket shaft 1.
Remove ground cable on the swivel bracket.
Remove swivel bracket shaft with spring and swivel
bracket.
GB
2st X50D2 2011