Selection Of Washer Thickness - TOHATSU MX 50D2 Service Manual

Lower Unit
9
8
4
5
OBM OBM
OBM
When bolts are reused
1342
1342
4 O Ring
Do not reuse.
MX50
Propeller Shaft Housing Bolts :
6 N · m (4 lb · ft) [0.6 kgf · m]
1342
1342 1342
6-98
7
6
37) Measurement of Propeller Shaft
Attach O ring 4 to propeller shaft housing 5.
3.
Apply OBM grease to O ring.
Attach steel ball 6, clutch push rod 7 and washer 8 that was
4.
removed when disassembling to propeller shaft 9.
Install propeller shaft 9 to propeller shaft housing 5, and
5.
install the assembly to gear case.
· Install propeller shaft housing to gear case
securely, and tighten the securing bolts after
confirming that O ring is set in the case properly.
· Apply ThreeBond 1342 to thread of propeller
shaft housing installation bolts.
MWX50
Propeller Shaft Housing Bolts :
13 N · m (9 lb · ft) [1.3 kgf · m]
MWX50 only
Play and Selection of Washer
Thickness
Before measuring propeller shaft play,
adjust backlash between forward (A) and
pinion (B) gears and reverse (C) and pinion
(B) gears.
Refer to "Measurement of Backlash
between Forward (A) and Pinion (B) Gears
and Shim Selection" and "Measurement of
Backlash between Pinion (B) and Reverse
(C) Gears and Shim Selection" in Chapter 6.
1. Assemble lower unit parts in accordance with procedure
described in "Assembly of Lower Unit Parts" on Chapter 6.
2. Measure play of propeller shaft in forward and reverse
directions.
CAUTION
2st 50D2 2011
GB