TOHATSU MX 50D2 Service Manual page 384

Lower Unit
4
3
5 Spring Pin
Do not reuse.
8 Split Pin
Do not reuse.
6-104
5
6
8
7
Connect shift rod joint 3 and shift rod 4, and drive in
5.
spring pin 5.
· Do not reuse spring pin.
· Replace with new one when removed.
Spring Pin Tool B 6 : (ø3.0)
P/N. 345-72228-0
Attach propeller and tighten propeller nut 7 to specified
6.
torque.
· Before removing or installing propeller, be
sure to remove stop switch lock plate.
· When removing or installing propeller, do
not handle propeller with bare hands.
· Put a piece of wooden block between
anti-ventilation plate and propeller to
prevent rotation of propeller when
removing or installing propeller.
Propeller Nut 7 :
35 N · m (25 lb · ft) [3.5 kgf · m]
Attach split pin 8.
7.
If propeller shaft pin hole and propeller nut
pin groove do not align, additionally tighten
the nut until they align.
8. Fill gear case with gear oil to specified level.
Refer to "Replacement of Gear Oil" in Chapter 3.
Perform "Inspection of Gear Case (Air Leakage)"
in Chapter 3 if necessary.
CAUTION
CAUTION
2st 50D2 2011
GB