Inspection Date; Resistance Test Reference; Peak Voltage Out Put Test Reference - TOHATSU MX 50D2 Service Manual

Electrical System

4. Inspection date

Resistance test reference

Ignition coil
Pulser Coil
Exciter Coil

Peak voltage out put test reference

Pulser Coil
Exciter Coil
C.D unit
8-10
6) Measure peak voltage at engine cranking or engine
starting.
• When measuring peak voltage at engine
cranking, remove spark plug cap from spark
plug and spark plug is attached.
• Variation occurs in output value with cranking
speed.
• For manual start model:
Cranking speed is unstable, cranking
measurement makes reference value.
• Because numerical value of the data of each
model statement page is the lower limit, if it is
above this, as for good condition.
• The faulty part it specifies, input voltage being
properly, if there is a unit whose output voltage
is not properly that is the faulty part.
Primary
Secondary
L/W - B #1
WB - B #2
WR - B #3
W/G - B
Or - B
Or - W/G
Cranking
L/W - B #1
WB - B #2 3V
WR - B #3
Or - W/G 185V
B/W - B
B/R - B 160V
B/G - B
GB
0.4 ~ 0.6Ω
6.8 ~ 10.2 kΩ
160 ~ 220Ω
160 ~ 220Ω
160 ~ 220Ω
∞
∞
520 ~ 720Ω
Idling 1500r/min
7V 19V
210V 210V
180V 180V
2st 50D2 2011