Inspection Of Shift Lever Gear Operations - TOHATSU MFS 25D Service Manual

Maintenance
19) Inspection of Shift Lever Gear
Operations
Shift the gear from neutral (N) to forward (F) or reverse
(R) and check that the gear changes smoothly. Adjust the
position of the shift arm 1 and the joint position of the shift
rod as well as the cam rod if necessary.
1. Remove the cable joint.
Remove the shift rod joint retainer 2.
2.
3. Remove the spring pin then disconnect the shift rod.
Remove the shift rod joint 3.
• Use the spring pin tool A 4 to remove it.
• The spring pin cannot be reused once it is
removed.
Spring Pin Tool A 4:
P/N. 345-72227-0
4. Set the shift arm to the forward position.
Align the cam rod 5 to the forward position, turn the shift
5.
rod joint so that the hole for the shift rod and the part to
insert the shift rod 6 are at the same position a.
6. Attach the spring pin then install the shift rod joint retainer.
Apply a thin coat of water-resistant grease on the
shift rod joint retainer.
7. Adjust the length so that the position of the hole of the
cable joint 7 aligns with the pin of the throttle arm and
shift arm. (Multi-Function Tiller Handle Control Model,
Remote Control Model)
Screw in a minimum of 10 mm (0.39 in) b of
the cable joint.
When adjusting the cable joint, adjust it with the
cable fully pushed in.
3-28
WARNING
R
F
N
4st 25/30 2022