Inspection Of Shift Lever Gear Operations - TOHATSU MFS25 Service Manual

16. Reconnect cord ass'y connectors.
Do not disconnect cord ass'y while engine
operates.
Run cord ass'y a and remote control cables s through
17.
grommet p located on the front of bottom cowl. Attach
remote control cable groove to bracket, and then fix it to
bottom cowl.

18) Inspection of Shift Lever Gear Operations

Shift gear from neutral (N) to forward (F), neutral (N), and
then to reverse (R) to check that shift operation is performed
smoothly. Adjust shift link rod 1 length and shift cable
position if necessary.
1. Shift gear into neutral (N).
Remove shift link rod 1.
2.
Check and adjust standard length a of shift link rod 1.
3.
Remote control model a : 52 mm ( 2.05 in )
Tiller handle model a : 144.5 mm ( 5.69 in )
Check that shift lever shaft 3 and shift arm 2 are vertical.
4.
5. Perform shift adjustment after assembling lower unit.
(Tiller Handle Model)
Remark: The adjustment is difficult when power head has been
installed.
Loosen shift lever stopper bolt 4.
Set shift lever shaft ass'y 5 fully to forward, adjust shift lever
stopper 6 position, and then, tighten shift lever stopper bolt 4.
Separate shift lever to check that operation from neutral (N)
to forward (F) to neutral (N) to reverse (R) is normal and
forward and reverse movements are equal to each other.
25/30 2006
CAUTION
p
a
3
a
R
4
6
5
a Oval Hole
3
s
1
2
F
a
3-23