Inspection Of Propeller Shaft Ass'y - TOHATSU MX 50D2 Service Manual

Lower Unit
7
a
a Supporting Points
c
b
6-48
3.
4
1
4.

17) Inspection of Propeller Shaft Ass'y

1.
2.
a
3.
Pull out clutch pin 4, and remove clutch spring retainer
5, clutch spring 6, and clutch by referring to the figure.
WARNING
· When removing
protective glasses, and do not point
opening of propeller shaft to your face or
body while holding the propeller shaft.
Clutch pin or spring holder may fly out
very quickly.
· Install push rod 1, and pull out pin 4
while pushing propeller shaft onto a plane
to prevent retainer 5 and spring 6 from
flying out.
After taking out clutch spring retainer 5 and clutch spring
6, remove clutch 7 from propeller shaft.
Check propeller shaft for bend, wear and damage.
Replace if necessary.
Measure propeller shaft runout.
Runout Limit :
0.05 mm (0.0020 in)
Check clutch claw b and push rod c for crack and wear.
Replace if necessary.
GB
clutch pin, wear
2st 50D2 2011