Disassembly Of Cam Rod - TOHATSU MX 50D2 Service Manual

Lower Unit
1
6
2
Spring Pin Tool A 3 (ø3.0) :
P/N. 345-72227-0
X50
5
6
5 O Ring
Do not reuse.
b
6-26
X50
3
WX50
5
6
a

4) Disassembly of Cam Rod

1. Remove stopper, pull out cam rod bushing, and take out
cam rod from gear case.
When removing cam rod bushing, put a bladed
screw driver into groove of the bushing and pull
out while lifting it.
Remove shift rod joint 1 and clutch cam 2.
2.
6
2
Spring Pin Tool A 3 (ø3.0) :
P/N. 345-72227-0
Spring Pin Tool A 4 (ø3.5) :
P/N. 369-72217-0
Remove O ring 5 from cam rod bushing 6.
3.
5) Inspection of Clutch Cam
1. Check the part for wear and damage.
Replace if necessary.
Check especially for wear on the face a that
scrapes against push rod and flaws on the
circumference b.
WX50
1
3
4
2st 50D2 2011