Ass'y - TOHATSU MX 50D2 Service Manual

Lower Unit
4
5
5 Bearing
Do not reuse.
6-38
1
3
2
13) Disassembly of Propeller Shaft
Housing Ass'y
Pull out propeller shaft ass'y 1.
1.
Remove reverse (C) gear 2 by using bladed screw
2.
drivers 3.
Check oil seal 4 for wear and crack.
3.
Replace if necessary.
Remove bearing 5.
4.
Heat propeller shaft housing by putting it in
the hot water of approximately 60 - 70˚C
(140 - 158˚F), and remove bearing 4.
Be careful not to burn.
Heating of propeller shaft housing can also be
made by using a heat gun or heat lamp.
CAUTION
CAUTION
2st 50D2 2011
GB