Other Modes - Kyocera Mita FS-9500DN Operation Manual

Chapter 3 Using the Operator Panel
5
Press the ENTER key. A question mark (?) appears.
>Reset Type
Adjust ?
6
Press the ENTER key. All the customized paper weight
and duplex path settings will be reset to the default.
The message display returns to Ready.
Q Q Q Q Verifying the Total Printed Pages and Resetting the Ton-
er Counter
You can display the total number of pages printed by your print-
er for confirmation whenever necessary. The total number of
printed pages can also be checked on the status page. More-
over, for proper maintenance scheduling, it will be necessary to
reset the toner counter using this menu each time a new toner
container is installed.
Q Q Q Q Verifying the Total Printed Pages
This procedure only displays the total number of printed pages.
The number cannot be changed.
1
Press the MENU key.
2
Press the 3 or 4 key repeatedly until Life
Counters > appears.
Life Counters
3
Press the 2 key.
4 Press the 3 or 4 key until >Total Print appears.
>Total Print
0123456
5
Press the MENU key. The message display returns to
Ready.
Q Q Q Q Resetting the Remaining Toner Counter
If the toner container was replaced when Replace
Clean Printer was not displayed, reset the toner counter as
follows so that an accurate toner gauge measurement is indi-
cated on the status page. Note that if this operation is per-
formed when the toner container is not replaced, the toner
gauge measurement will not be indicated correctly. Also refer to
the Installation Guide supplied with the toner kit when replacing
the toner container.
1
Press the MENU key.
3-47
>
toner
2
Press the 3 or 4 key repeatedly until Life
Counters > appears.
Life Counters >
3
Press the 2 key.
4 Press the 3 or 4 key repeatedly until >New Toner
Installed appears
>New Toner
Installed
5
Press the ENTER key. A question mark (?) appears.
>New Toner
Installed ?
6
Press the ENTER key. The toner counter is reset.
7
Press the MENU key. The message display returns to
Ready.

2.2.13 Other Modes

The modes described in the following pages can be accessed in
the Others submenu. To enter the Others submenu, press the
2 key while Others > is displayed.
The following submenus can be displayed by pressing the 2
key and then the 3 or 4 key.
• Message Language Selecting
• Automatic Form Feed Timeout Setting
• Sleep Timer Setting
• Received Data Dumping
• Printer Resetting
• Resource Setting
• Alarm (Buzzer) Setting
• Auto Continue Setting
• Service Menu (for service personnel)
Message Language Selecting
You can select the language of the messages on the message
display by following the procedure given below.
1
Press the MENU key.