Table of Contents
Advertisement
Authorized button
Authorize the device selected in the list as a child device.
Authorize a child device to enable the panel link function.
Note
Regardless of the authorization status of the child device,
control from the parent device to the child device is
possible, but control from an unauthorized child device is
not possible.
Deauthorized button
Deauthorize the child device selected in the list.
Page Group Settings Page
(Not supported on the MKS-E1620.)
Use to register consecutive pages on the [Panel Table]
page as a page group.
Setting a page group
1
Double-click a group number to set, or select a row
and click the [Edit] button.
2
Specify the group name, and the first and last pages
in the dialog. Place a check mark in [Enable Group]
for the group to use.
3
Click the [Apply] button.
Network Settings Page
Use to configure settings related to the network.
LAN Settings
Enable Redundancy
Select to enable redundancy using LAN1 and LAN2.
If a redundancy configuration is not used, use the LAN1
port.
Automatic IP address assignment (DHCP) - Using
both LAN1 and LAN2
Automatically obtain IP addresses of the remote control
panel, system controller, and NTP server.
When a check mark is placed in [Enable Redundancy],
redundancy dual LAN connection is used.
Note
Cannot be selected in LEO connection mode or Hybrid
connection mode.
Manual IP address assignment (Static IP) - Using
both LAN1 and LAN2
Set the IP address manually.
When a check mark is placed in [Enable Redundancy], set
[LAN1] and [LAN2]. The connection becomes a redundancy
dual LAN connection.
When there is no check mark, set [LAN1]. The connection
becomes a single system connection.
Manual IP address assignment (Static IP) - Using
only LAN1
Set the IP address manually.
When a check mark is placed in [Enable Redundancy], set
[LAN1] and the IP address of the redundancy connection
destination. The connection becomes a redundancy single
LAN connection.
When there is no check mark, set [LAN1]. The connection
becomes a single system connection.
LAN1, LAN2
Configure network settings for LAN1 and LAN2.
IP address: IP address
Subnet mask: Subnet mask
Default gateway: Default gateway
System Controller: IP address of system controller (not
available on the MKS-E1620)
Ntp Server: IP address of NTP server
LEO: IP address of LEO
System Controller Protocol
Select to use the TCP protocol or TLS protocol for
communication with the system controller.
LEO Protocol
Select to use the TCP protocol or TLS protocol for
communication with LEO.
Note
The [LAN Settings] configuration is applied when the
[Apply] button is clicked.
Remote Maintenance Page
Use to configure settings related to SNMP.
SNMP Settings
Enable SNMPv1
Place a check mark in the checkbox to use SNMP v1.
Enable SNMPv2c
Place a check mark in the checkbox to use SNMP v2c.
Common
Contact Information: Enter contact information for the
administrator.
System Name: Enter the name for management.
System Location: Enter location information for
management.
SNMPv1/SNMPv2c
Community Name (Read Only): Set the community name
for retrieving read-only information.
Allowed Host: Configure settings for hosts with permission
to connect.
• NONE: Block access from all IP addresses.
• Specified: Allow access from specific IP addresses.
• ANY: Allow access from all IP addresses.
Allowed Host1: Set the IP address with permission to
connect when [Allowed Host] is set to [Specific].
LAN1, LAN2: Select the LAN to use by the host specified in
[Allowed Host1].
Allowed Host2: Set the IP address with permission to
connect when [Allowed Host] is set to [Specific].
20
Advertisement
Table of Contents
