Waste/Toilet System; Fresh Water System - Regal 3760 Owner's Manual

FRESH WATER SYSTEM:

1. Turn on the fresh water pump switch.
2. Open all faucets including transom shower and allow
tank to empty.
3. Drain the water heater; shut off water pump switch.
4. Mix nontoxic antifreeze with water in accordance
with the manufacturer's recommendations.
5. Pour solution into the fresh water tank.
6. Turn on fresh water pump switch.
7. Open each cold water faucet one by one beginning
with the one furthest away from the tank and purge
the system until a steady stream flows from the faucet.
Then close the faucet.
8. Repeat step 7 for hot water faucets.
9. Shut off water pump switch.
10. Pour a quart of antifreeze into shower drain. Run the
shower pump until a steady stream flows from the
discharge fitting.
11. Leave at least 2 gallons of antifreeze solution in the
holding tank during storage.

WASTE/TOILET SYSTEM:

1. Pump out waste holding tank, flush the tank with
fresh water and pump out again.
2. With antifreeze in the fresh water tank, operate head
until antifreeze flows into bowl of head. Allow time
between flushes for the vacuum to build up.
3. Operate macerator until antifreeze has a steady flow
coming from the discharge fitting. Pour antifreeze
solution in head and flush head as needed to produce
enough flow to winterize the macerator.
4. Leave at least 2 gallons of antifreeze solution in the
holding tank during storage.
4
Chapter 10