Stern Drive; V-Drive; Boat - Regal 3760 Owner's Manual

STERN DRIVE

Change engine and stern drive oil along with steering
fluids.
Remove drive. Perform maintenance as referenced in
the manufacturer's owners manual including checking
seals for vacuum and pressure.
Check all belts for wear and tension.
Remove propeller. Refurbish as needed.
Touch up paint on stern drive upper and lower gear
housings as required.
Check exhaust, fuel, and cooling systems for leaks.
Keep the unit trimmed down to assist in draining any
water still in the exhaust system. Also, this position allows
the universal to set without extra pressure on the bearings.

V-DRIVE

Winterize engine as required.
Remove propellers. Refurbish as needed.
Touch up engine paint as required.
Apply rust inhibitor to engine.
Change engine oil, transmission fluids and steering
fluids.
Check all belts for wear and tension.
Apply rust inhibitor to engine.
Check exhaust, fuel, and cooling systems for leaks.

BOAT

Check hull bottom for any fiberglass damage. Repair
as needed.
Apply a coat of wax to hull and deck surfaces.
Pour a pint of 50/50 antifreeze into bilge pump.
Remove batteries. Charge as needed.
Remove all loose gear from boat such as life jackets,
etc. Inspect and store in cool, dry environment.
Remove drain plug. Clean drain plug hole of debris
as needed. Enclose drain plug in plastic bag and tie to
steering wheel.
Drain the waste system per instructions in this chapter.
Make sure bow is higher than stern to permit proper
drainage.
Clean all upholstery and store so it breathes.
Conduct a visual inspection to ensure boat is balanced
properly on the trailer, cradle or blocks.
Cover boat with tarp. Tie down for wind protection
if outside. Prop tarp up as needed to provide proper
ventilation. Be sure not to cover up the fuel vents.
Drain the fresh water system per instructions in this
chapter.
Send in appropriate equipment for calibration such
as the automatic fire extinguisher canister or the CO
detectors.
2
Chapter 10