Ice Maker Inlet Screen; Ice Cube Thickness Adjustment - Regal 3760 Owner's Manual

ICE MAKER INLET SCREEN

Once per boating season the solenoid valve inlet screen
must be cleaned as follows:
1. Turn the icemaker breaker off at the ship's AC panel.
2. Shut off the water to the unit. There is a shut-off valve
located behind the grille.
3. Pull the unit out to access the back panel.
Hose Connector
4. Disconnect the hose connector from the water
solenoid valve.
5. DO NOT remove the inlet scren from the water
solenoid valve. Use a tooth brush to gently clean any
sediment from the inlet screen.
6. Refasten the water supply hose connector to the water
solenoid valve. Tighten the connection securely.
7. Open the water supply valve and check for leaks. Make
sure the water supply line is not kinked.
8. Reconnect power to the unit before re-installing.
Cosmetic Care & Maintenance
Solenoid Valve w/ Inlet Screen

ICE CUBE THICKNESS ADJUSTMENT

The ice cube size may be adjusted by changing the amount
of water injected into the ice maker as follows:
1. Remove the ice maker cover.
2. Locate the adjusting screw on the ice maker control
box. The adjusting screw is just below the minus(-) and
plus (+) signs on the control box. Make adjustments in
small increments. Too large of an adjustment could cause
the unit to malfunction such as water overflowing and
could cause property damage.
3. Turn the adjusting screw toward the (-) sign (clockwise)
for smaller cubes or toward the plus (+) aign for larger
cubes.
4. Install the ice maker cover assembly.
Screwdriver Shown
At Adjustment Screw
41