Antenna-Gps; Circulation Mode; Moisture Mode; Program Mode - Regal 3760 Owner's Manual

Circulation Mode

When the system is off at the control panel the fan can be
used to circulate air only. Press and hold the FAN button
when the display is off until the desired speed number
appears in the window. Release the FAN button and the
fan will run at the selected speed circulating the air with-
out heating or cooling. Press the POWER button once to
cancel the CIRCULATION mode and enter the ON
mode.

Moisture Mode

While in the ON mode simultaneously press the POWER
and DOWN buttons. The first cycle will start in one
minute. Every 4 hours, the fan is started and air circu-
lated for 30 minutes. During this time the air tempera-
ture is sampled and entered into memory. The cooling
cycle is started and continues until the temperature is low-
ered 2 degrees F. The compressor is allowed a maximum
of 1 hour running time to reach the desired temperature.
Four hours after the temperature is satisfied or the com-
pressor times out, the cycle is repeated. The "HU1" code
is displayed while in the MOISTURE mode.

Program Mode

The PROGRAM mode is used to adjust the systems op-
erating parameters to suit the particular needs of indi-
vidual users. The PROGRAM mode is also used to taylor
the air conditioning system for the most efficient
operaiton within an installation. Refer to your Marine Air
Systems Manual for detailed instructions on the program
mode.
Equipment Operation

ANTENNA-GPS

The GPS antenna is located on top of the radar arch or
optional hard top. The antenna features a built-in posi-
tion fixing receiver. The helm breaker panel switch la-
beled GPS/Plotter provides protection for the antenna
circuit. The GPS features a filter that compensates for
the rolling motion of your boat for clearer course and
speed information.
At the top of the antenna dome there is an indicator
lighthat tells which tells the status mode of the antenna.
1. Flashing RED indicates the unit is in bootcode, either
being upgraded or unable to boot.
2. Flashing ORANGE indicates the unit is running but
does not have a fix.
3. Flashing GREEN indicates the unit is running and
has a fix.
1 flash every 2 seconds indicates NMEA connection.
1 flash every 4 seconds indicates Sea Talk connection
where optional equipment is installed.
9
Indicator Light