Projector Communications - Christie J Series Setup Manual

2.2.5

Projector Communications

Status LEDs
Looking from the back of the projector, the LEDs represent, from left to right; Lamp, Comm, Status, and
Shutter. The LEDs will display the colors as shown below:
Status LEDs
Lamp
Comm
Status
Shutter
NOTE: A condition occurs on the first power on after a software upgrade, and is indicated by all the following:
• The Status LEDs are cycling green
• The LCD displays the warning "Image Processor Upgrading"
• The LED on the Image Processor card flashes green
• The Web page shows a warning that the Image processor card is upgrading.
When this occurs, the projector should not be AC power cycled and the Image Processor card should not be removed.
J Series 2.0, 2.4, and 3.0 kW Setup Guide
020-100751-01 Rev. 1 (10-2011)
#
1 Off - lamp off
Yellow- Lamp time has expired and lamp should be
replaced
Green - Lamp is on and operating correctly
Flashing Red - Lamp has malfunctioned
Flashing Yellow - Lamp door is open
2 Flashing Green - Projector communication in progress
3 Off - AC power is off
Yellow- AC is present but projector is in standby
Green -Projector is powered up and operating normally
Flashing Red - Error has occurred. Details are displayed
on the status display
4 Green - Shutter is open
Yellow - Shutter is closed
Section 2: Installation and Setup
LED State
2-11