Actual Frame Delay; Power Management; Auto Power Up; Auto Shutdown Enable - Christie Matrix StIM-WQ User Manual

Configure the Display

Actual Frame Delay

This control indicates the dynamically calculated, effective minimum frame delay for the projector.

Power Management

To access the Power Management menu select Configuration > Power Management from the
main menu.

Auto Power Up

If there is an AC power interruption while Auto
Power Up is enabled, the projector will resume
operation in the same state as it left off. If the light
engine is On and an image showing when AC power is
lost, the projector will automatically power back up,
and an image will show when AC is restored.

Auto Shutdown Enable

When Auto Shutdown Enable has been selected, and no projector activity has been seen for the
activation time-out period, the projector will enter a power-saving mode in which the light engine will
dim and the shutter will close. If this condition persists for an additional time-out period, the
projector will automatically go into Standby mode. The presence of any activity within this combined
interval will cancel auto shutdown and return the projector to normal operation.

Turn Off Image After (min)

This sets the activation interval (in minutes) for auto shutdown. If all activity (input signals, Web or
Serial port activity key presses) is lost for this length of time, and auto shutdown is enabled, an auto
shutdown cycle will begin.

Enter Standby After (min)

This sets the interval (in minutes) between starting Auto Shutdown and entering Standby mode.
Once Auto Shutdown has been entered, and all activity continues to be absent for this interval, the
projector will automatically enter power Standby mode.

Stealth Mode

Check this option to operate the projector with the status LED display on the input panel powered
Off. The status LED is powered Off during operation only. In Standby mode, the status LED displays
codes normally. Operating in Stealth mode is recommended when images are displayed using only
60 Matrix StIM™ WQ/SIM WQ User Manual
020-100883-01 Rev. 2 (06-2013)