Turning The Projector On; Projector Led Status Indicators; Projector Led Shutter Indicators - Christie Boxer 4K30 User Manual

Turning the projector on

Warning! Failure to comply with the following could result in death or serious injury.
• Do not attempt to turn the projector on if the AC supply is not within the specified voltage range.
1. Plug the projector in to AC power.
The projector automatically powers on when plugged in. The side panel display functionality
becomes available.
2. To turn the lamps on, press and hold the Power button until you hear a beep.
For more details on the specified voltage range, see

Projector LED status indicators

The table identifies the LED state colors and meaning.
LED State
Blue Solid Standby
Flashing Cool down
Green Solid Lamps on
Flashing Startup
Yellow Solid Warning in standby
Flashing Warning during startup
yellow/
green
Flashing Warning with lamps on
Flashing Warning during cool
yellow/ down
blue
Red Solid Error in standby
Flashing Error
Off AC off

Projector LED shutter indicators

The table identifies the LED state colors and meaning.
Boxer 4K30 User Manual
020-101777-01 Rev. 1 (03-2015)
Power requirements
Description
Lamps are off. Video electronics are off. Projector status is OK.
Projector is moving to one of the two standby states:
• Lamps are off and video electronics are booting up.
• Lamps are off. Video electronics and lamps are cooling down.
Lamps are on. Projector status is OK.
Projector is moving to lamp on state. Lamps are striking and
warming up. Video electronics are initializing.
Projector is in standby state. A problem exists with the projector
that does not prevent it from operating.
Projector is in a startup state. A problem exists with the projector
that does not prevent it from operating.
Lamps are on. A problem exists with the projector that will not
cause it to shut down.
Projector is in a cool down state. Lamps are off. Video electronics
and lamps are cooling down. A problem exists with the projector
that does not prevent it from operating.
Projector is in standby. An error exists that prevents the projector
from starting up.
An error with the projector exists during startup, cool down, or
when the lamps are off. Projector will proceed to shut down.
The AC power is off.
Introduction
on page 37.
15