Table of Contents
Advertisement
When a malfunction or system failure occurs,
1. Turn off the projector.
2. Disconnect the power plug.
3. Connect the plug of the power cable to the projector.
4. Turn on the device.
5. If steps 1 to 4 did not lead to the required result, contact Christie Technical Support or an
authorized Christie service center.
LED status indicator
LED status indicator helps identify the projector state. LEDs are defined below.
Status LED
Identify the LED state colors and meaning.
LED status
Projector state
Off
AC power is off (without AC plugged in).
Green (flashing)
Projector is starting up.
Green (solid)
System is operating normally.
Blue (flashing)
Projector is cooling down.
Blue (solid)
Projector is in standby mode.
Yellow (flashing)
A problem exists with the projector that does not cause it to shut down.
Examples of warnings include: filter needs changing, one of the pumps is damaged, or a
fan is operating at full speed due to over temperature of laser diode (LD) driver.
Yellow (solid)
The end user is turning off the projector while it is in a warning state.
Red (flashing)
An error with the projector exists causing it to shut down.
Examples of errors include: fan failure, over temperature, wrongly installed filter, or color
wheel (CW) failure.
Red (solid)
The user is turning off the projector while it is in an error state.
White (flashing)
Projector is in a flash (LAN) update state.
Shutter LED
Identify the shutter LED state colors and meaning.
LED Status
Projector State
Off
Projector is on and an image is displayed. Shutter is open.
Magenta (solid)
Projector is on and the image is blank. Shutter is closed.
Inspire Series Installation and Setup Guide
020-002097-01 Rev. 1 (11-2023)
Copyright ©2023 Christie Digital Systems USA Inc. All rights reserved.
If printed, please recycle this document after use.
Installation and setup
24
Advertisement
Table of Contents
