Projector Led Shutter Indicators; Calibrating The Lens Motor; Removing The Projection Lens - Christie Mirage SST Installation And Setup Manual

LED State
Red Solid
Flashing
Off

Projector LED shutter indicators

Identify the shutter LED state colors and meaning.
LED
Solid magenta
Off

Calibrating the lens motor

Ensure the lens motor is calibrated before using the projector.
If the lens motors are not calibrated properly, implications may include:
• Incorrect reporting of the lens motor position.
• Inability to use the full range of the lens motors.
• Lens motors traveling outside of the pre-defined keep-out area.
• Damage to the projector.
Calibrate the lens motors when any of the following conditions are met:
• After a lens change.
• After the projector is moved and/or jostled.
• After any manual adjustment is made to the zoom or focus.
To calibrate the lens:
1. Select MENU > Configuration > Lens Settings > Lens Calibration.
2. Select Enter.

Removing the projection lens

Use the correct method of removing the lens.
1. Turn off the lasers.
2. Push in and hold the lens release button.
Mirage SST Installation and Setup Guide
020-102956-08 Rev. 1 (09-2022)
Copyright © 2022 Christie Digital Systems USA, Inc. All rights reserved.
If printed, please recycle this document after use.
Error in
standby
Error
AC off
State
Shutter closed
Shutter open
Description
Projector is in standby. An error exists that
prevents the projector from starting up.
An error with the projector exists during startup,
cool down, or when the light source is off. Projector
will proceed to shut down.
The AC power is off.
Description
The shutter is closed.
In standby, the shutter is always automatically closed and
the magenta light is muted.
The shutter is open.
Installation and setup
47