Advanced Tab - Real Time Events (Rte); Add A Scheduled Event - Christie Matrix StIM-WQ User Manual

Basic WebUI Operation

Advanced Tab - Real Time Events (RTE)

The RTE tab is where you can manage real-time events (i.e. add, delete, edit, copy and setup the
GPIO).

Add a Scheduled Event

Scheduled events include a command or sequence of commands, for example, (PWR1) or (PWR1)
(LSH1).
1. From the Advanced tab, click Add to open the
RTE Wizard.
2. Select the Scheduled Event tab.
3. Select the frequency option for the event by
selecting either Once, Daily, Weekly, or
Monthly. End Date is enabled when Daily,
Weekly or Monthly repeat options are
selected. Depending on the selected frequency
option, a related Repeat Every is highlighted
on the tab. Use this area to enter the
frequency of each event.
4. Click within the Start Time field to open a
calendar pop-up window.
5. Navigate to and choose the desired date. The selected date will populate the Start Time field.
6. In the field below the Start Time field, enter a start time in the format "hr:min:sec". The setting
defaults to the current time.
7. Click Sync to set the computer and projector time to be the same; otherwise, the event will run
based on the projector time.
8. Enter a description of the scheduled event in the Description field.
9. Enter a serial command or a sequence of serial commands, with which you wish the projector to
perform in the Command String field.
10. If a GPIO command string is needed, click the
GPIO Output Helper button for instructions
on how to create the command structure. The
Output field contains 7 blocks which refer to
the 7 I/O pins on the GPIO connector. 
Pin 1 = +12V and Pin 5 = Ground. These are
not included. Clicking a block toggles between
H, L, and X. See
page 77 for details.
34
Serial Communication on
Matrix StIM™ WQ/SIM WQ User Manual
020-100883-01 Rev. 2 (06-2013)