Installing the webcam driver
Installing the Logitech HD Pro Webcam C920 driver makes sure the Auto Warp application functions as
expected.
1. Navigate to the Logitech website for the Logitech HD Pro Webcam C920:
http://www.logitech.com/en-us/support/hd-pro-webcam-c920?
section=downloads&bit=64&osid=14&softwareFile=on
2. Select Downloads.
3. Under Windows, select the appropriate operating system.
The Auto Warp application supports Windows XP, Windows 7 (32-bit or 64-bit), and Windows
8.
4. Select Download.
5. In the Opening dialog, select Save File.
6. Navigate to where you downloaded the file and double-click lws251.exe.
7. Select Run.
8. To complete the installation, follow the Logitech Webcam Software Installation wizard.
Installing the Auto Warp application
Install the Auto Warp application on a computer running Windows XP, Windows 7 (32-bit or 64-bit), or
Windows 8.
To install the Auto Warp applicable, run Auto AP Setup.exe.
The Auto Warp application shortcut is installed on the desktop.
Reverting all settings
At any time, you can revert all settings back to their default settings.
From the Auto Warp homepage, select Reset.
Restoring previously saved warping settings
If the currently set warping settings are not correct or as expected, you can apply the previous
geometry correction.
From the Auto Warp homepage, select Resync.
Adjusting the brightness of the blending zone
Adjust the brightness of the gradient by increasing or decreasing the gamma of the blend zone.
1. From the Auto Warp homepage, select Others.
2. In the Edge Blending Settings dialog, adjust the Gamma slider to the brightness required.
The brightness can be adjusted from 0 to 10.
H Series, HS Series, GS Series, and Inspire Series User Guide–Auto Warp
020-102080-05 Rev. 1 (01-2024)
Copyright
©
2024 Christie Digital Systems USA, Inc. All rights reserved.
If printed, please recycle this document after use.
Auto Warp application installation
6