ARM ARM926EJ-S Technical Reference Manual page 130

Tightly-Coupled Memory Interface
5-22
• If a fast design is more important than minimizing power consumption, you must
follow the example in Optimizing for speed on page 5-23.
The rules for producing memory out of smaller RAM blocks are:
• There must be an even number of RAM blocks b (b = 2, 4, 8, for example)
• Each RAM block must be the same size.
• If the address width of the required memory size is n bits, the address port of the
smaller RAM blocks is m = n-(log
• Address bits [m-1:0] are applied to all the RAM blocks.
• Address bits [n-1:m] are gated with DRCS for a power optimized solution, or
with IRnRW for a speed optimized solution.
• Pipelined address bits [n-1:m] are used to select the correct RAM read data.
Optimizing for power
Figure 5-14 on page 5-23 shows how to produce a large memory from two smaller
RAM blocks if you are optimizing for power. Separate chip select control is required
for each RAM block:
CS_bank0 = ~DRADDR[14] & DRCS
CS_bank1 = DRADDR[14] & DRCS
This ensures that only the RAM being accessed is enabled, minimizing power
consumption.
Copyright © 2001-2003 ARM Limited. All rights reserved.
/log ) bits wide.
b 2
ARM DDI0198D