Table of Contents
Advertisement
Default Gateway Address
1. To check that the unit received the default gateway address, enter:
*ICAD*>
The unit responds with a display similar to the following:
Destination
-------------------------------------------------------------
0.0.0.0
195.206.164.1
127.0.0.1
192.168.1.0
2. Look at the route with the
address shown under
correct, skip to the procedure
3. If the address is incorrect or the table does not have a default route, enter the
correct default gateway address:
*ICAD*>
4. To verify that the new default route is correct, enter the
again:
*ICAD*>
DNS Server
1. To check that the unit has the address of a DNS server, enter:
*ICAD*>
The unit responds with a display similar to the following:
DNS Settings:
2. Look at the line DNS1. The address on this line is that of the primary DNS
server. If the DNS settings are correct, go to
3. If the address is incorrect or unspecified (0.0.0.0), enter the correct DNS
server address. You can also enter an optional domain name with the
command:
*ICAD*>
25
NN47928-303
Lease expires
MAC Address
Speed
Configured Speed
show route table
Gateway
66.206.164.193
195.216.164.1
127.0.0.1
192.168.1.1
Gateway
config route table default gw
show route table
show system dns
DNS1
192.168.134.160
DNS2
0.0.0.0
Domain wan.com
config system dns dns1
N/A
00:11:22:33:66:77
FULL100
AUTONEG
Netmask
0.0.0.0
255.255.255.224
255.0.0.0
255.255.255.0
Destination
0.0.0.0 and
is the default gateway address. If the address is
DNS Server (page
step 5.
address
BSGX4e Business Gateway Installation Guide
Interface
eth0
eth0
lo0
eth1
Netmask
0.0.0.0. The
25).
address
show
command
domain
name
Release 01.01
Advertisement
Table of Contents
