Chapter 9 W310 Wlan Gateway Default Settings; Configuring The Switch; W310 Default Settings - Avaya W310 User Manual

Chapter 9
W310 WLAN Gateway Default Settings
This section describes the procedures for the first-time configuration of the W310. The
factory defaults are set out in detail in the tables included in this chapter.

Configuring the Switch

The W310 may be configured using the text-based Command Line Interface (CLI), the built-
in W310 Device Manager (Embedded Web) or Avaya Multi-Service Network Manager™.
For instructions on the text-based CLI, see the Avaya0 W310 CLI Reference Guide.
For instructions on installation of the graphical user interfaces, see
Manager. For instructions on the use of the graphical user interfaces, refer to the W310
Device Manager User's Guide on the Documentation and Utilities CD.

W310 Default Settings

The default settings for the W310 switch and its ports are determined by the W310 software.
These default settings are subject to change in newer versions of the W310 software. See the
Release Notes for the most up-to-date settings.
Table 9.1
Function
IP address
Subnet Mask
Default gateway
Management VLAN ID
Spanning tree
Bridge priority for Spanning Tree
Keep alive frame transmission
Network time acquisition
Time server IP address
Avaya W310 User's Guide
Default Switch Settings
Embedded Web
Default Setting
149.49.32.134
255.255.255.0
0.0.0.0
1
Enabled
32768
Enabled
Enabled, Time
protocol
0.0.0.0
Continued
49