Chapter 4: Testing the complete configuration
This section provides tests for the complete configuration, including the control network,
signaling network, telephones, and consoles.
This section provides tests to:
Review the status of the configuration
●
Test the duplication link to the media servers (S8700-series only)
●
Test the IP server interfaces, expansion interfaces, and time-division multiplexing (TDM)
●
buses in the port networks (PNs)
Test the telephones and other equipment
●
For information about the LED status indicators for the Avaya Ethernet switches, uninterruptible
power supplies (UPSs), and circuit packs, see
Note:
Cabinet and slot usually indicate circuit pack positions. Port can also indicate
Note:
position. The term "cabinet" refers to five G650 Media Gateways that are
TDM-cabled together in a rack to make up one PN. A port network is defined as a
group of media gateways that are connected together with one TDM bus.
Perform the following tasks to test the configuration:
!
CAUTION:
To prevent unnecessary trouble tickets, do not enable the alarms, Alarm
CAUTION:
Origination feature, until you complete all installation and administration
procedures.
Testing port network equipment
●
Checking PN status for each media gateway
●
Checking circuit pack configuration
●
Testing the TN2312BP IPSl circuit pack
●
Testing bearer duplication with the TN2602AP circuit pack
●
Testing the TDM bus for each PN
●
Testing telephones and other equipment
●
LED indicators
on page 58
on page 58
on page 58
on page 59
on page 60
on page 61
on page 66.
on page 59
Issue 2 February 2007
57