Chapter 4: Connecting Devices; Step 1: Connecting Data And Voice Devices - Avaya G350 Installing And Upgrading

Chapter 4: Connecting devices

This chapter describes how to connect external endpoint devices to the G350, and install the
coupled bonding conductor.
Devices can be connected to the ports on the front panels of the installed media modules and to
the fixed front panel ports. Before you connect endpoint devices, the G350 should be mounted
and all media modules should be inserted.
This chapter describes various possible ways of connecting different devices. See your
planning documentation for any topology requirements to connect specific devices to specific
ports. As you connect devices, keep a record of the slots and ports into which specific devices
are connected. You will need this information when configuring the G350.
Perform the following steps in order:
Step 1: Connecting data and voice devices
●
Step 2: Install circuit protection
●
Step 3: Connect to the Wide Area Network (WAN)
●
Step 4: Install the Coupled Bonding Conductor
●
Step 5: Install the Avaya Partner Contact Closure Adjunct
●
The steps are described in the sections below.
!
WARNING:
To reduce the risk of fire, use only 26 AWG or larger telecommunication line
WARNING:
cords when installing telephones or adjuncts.
!
WARNING:
Attention: Pour réduire les risques d'incendie, utiliser uniquement des conductors
WARNING:
de télécommmunications 26 AWG ou de section supérieure.

Step 1: Connecting data and voice devices

The following sections describe how to connect various data and voice devices to the G350:
Connecting a switch or a network data port
●
Connecting a computer
●
Connecting a server
●
Connecting an IP telephone
●
Connecting an ISDN BRI station
●
on page 56
on page 47
on page 48
on page 49
on page 49
on page 56
on page 58
on page 59
on page 46
Issue 3.1 June 2006 45