Administering Station Parameters - Avaya G450 Manual

Administration

Hide thumbs Also See for G450:

Table of Contents

Administering Station parameters

1. At the gateway command prompt, enter station extension class to enter a

second-level sub-context to administer each phone that you want covered by SLS. In this

command, extension is a 1-13 digit numeric string that may begin with 0, and class is

analog, dcp, or ip.

The command line prompt changes to sls-station <extension> to indicate that you

are in the station context for SLS administration. Entering exit ends the station

configuration mode, and the command line prompt returns to its original state. If you want

to remove the station from the SLS administration, enter clear extension extension

at the command line interface. Enter exit to leave the second-level station context to

return to the (super-sls)# context.

station 1234567 ip administers an IP phone with the extension "1234567".

2. Depending on the class (analog, dcp, or ip, set in Step 1), enter set type model,

where model is a value from

Table 45: Class values in SLS station context

dcp6408D (default)

ip4620sw (default)

Configuring SLS

Issue 1 January 2008

Show Quick Links

Table of Contents