Configure Mld Snooping Leave-Timeout - Extreme Networks ExtremeWare XOS Command Reference Manual

configure mld snooping leave-timeout

configure mld snooping leave-timeout <leave_timeout_ms>
Description
Configures the MLD snooping leave timeout.
Syntax Description
leave_timeout_ms
Default
1000 ms.
Usage Guidelines
The range is 0 - 10000 ms (10 seconds). For timeout values of one second or less, you must set the leave-
timeout to a multiple of 100 ms. For values of more than one second, you must set the leave-timeout to
a multiple of 1000 ms (one second).
The specified time is the maximum leave timeout value. The switch could leave sooner if an MLD done
message is received before the timeout occurs.
Example
The following command configures the MLD snooping leave timeout:
configure mld snooping leave-timeout 10000
History
This command was first available in ExtremeWare XOS 11.2.
Platform Availability
This command is available on all platforms.
ExtremeWare XOS 11.3 Command Reference
Specifies an MLD leave timeout value in milliseconds, upon receiving an MLD
done message.
configure mld snooping leave-timeout
1595