Extreme Networks ExtremeWare XOS Command Reference Manual page 1626

Configuration and Image Commands
If you answer
The following command downloads the switch software image from the TFTP server at 10.10.15.04,
from the file named summitX450-11.2.0.15.xos:
download image 10.10.15.04 summitX450-11.2.0.15.xos
If you download an image into the active partition, you see output similar to the following:
Do you want to install image after downloading? (y - yes, n - no, <cr> - cancel) Yes
Downloading to
Switch..............................................................
Image will be installed to the active partition, a reboot required. Do
you want to continue? (y/n) Yes
Installing to primary partition!
..............................................................................
...............................................................................
...............................................................................
...............................................................................
.....................................
If you answer
History
This command was first available in ExtremeWare XOS 10.1.
The
memorycard
The parameter was added in ExtremeWare XOS 11.1.
msm
Platform Availability
This command is available on all platforms.
1626
to installing the image, the switch reboots upon completion of the installation.
yes
to installing the image, the switch reboots upon completion of the installation.
yes
option was added in ExtremeWare XOS 11.0.
ExtremeWare XOS 11.3 Command Reference