Setting The Default Flash - HP ProCurve Management And Configuration Manual

Table 6-2.
Actions
Save all
configuration
changes since the
last boot or reload
Perform all system
self-tests
Choice of primary or
secondary flash
image
Perform a scheduled
reboot

Setting the Default Flash

You can specify the default flash to boot from on the next boot by entering
the boot set-default flash command.
Syntax:
ProCurve(config)# boot set-default flash secondary
ProCurve(config)# show flash
Image Size(Bytes)
----- ----------
Primary Image : 7476770
Secondary Image : 7476770
Boot Rom Version: K.12.02
Default Boot : Secondary
ProCurve(config)# boot
This management module will now reboot from secondary and will become
the standby module! You will need to use the other management module's
console interface. Do you want to continue [y/n]?
Figure 6-13.Example of boot set-default Command with Default Flash Set to Secondary (with a
Redundant Management Module Present)
Comparing the Boot and Reload Commands
Included In
Boot?
Optional,
with prompt
Yes
Yes
No
boot set-default flash [primary |secondary]
Upon booting, set the default flash for the next boot to primary
or secondary.
Date
-------- -------
03/15/07 K.12.XX
03/15/07 K.12.XX
Switch Memory and Configuration
Using Primary and Secondary Flash Image Options
Included In Reload Note
Optional with reload
<cr>, when prompt
displays.
reload
Not saved with
at/after
commands;
No prompt is displayed.
No
No—Uses the current
flash image.
Yes
Version Build #
-------
64
64
Config changes saved to
the startup-config file if
reload
"y" is selected (
command).
The reload
command
provides a faster system
reboot.
reload
Use the command
with after/at parameters
(see page 6-25 for details).
6-21