Show Poe Power System - D-Link DGS-6600-48T Cli Reference Manual

DGS-6604 m

show poe power system

show poe power system [unit UNIT-ID [,-]] {power-info | parameters}
Syntax Description
unit UNIT-ID
, -
power-info
parameters
Default
Command Mode
Usage Guideline
Example
CLI Reference Guide
Use the command to display the setting and actual values of the whole POE
system.
(Optional) Specify the unit to be displayed. If no specified unit, all supported PoE
units are displayed. The value range of UNIT-ID is between 3 o 6.
(Optional)You can specify a range of UNIT-ID by a hyphen, or a series of UNIT-ID
by comma. There is no space before and after comma or hyphen.
This option could display the power information such as allocated power、used
power and unit priority of specific PoE unit.
This option could display the parameters such as max ports、device ID、SW
version、EEPROM status and configuration status for the PoE sub-system.
None
EXEC mode or any configuration mode
This command could display the detail power information and PoE chip
parameters for each PoE capable unit. As list of an UNIT-ID list is specified and
not all of units in the list are PoE capable, only the PoE capable units are
displayed.
The delim sign for specifying unit list supports two choices: hyphen (-) or comma
(,). The hyphen sign is used for displaying continuous units such as unit 2 to unit
4, and the format of the list will be "2-4". If you just want to check some units
specifically like unit 3 and unit 4 which is not continuously arranged, and the
comma sign can be used.
This example shows how to display PoE power system's power information.
show poe power system
814