Lldp Transmit - D-Link DGS-6600-48T Cli Reference Manual

DGS-6604 m

lldp transmit

lldp transmit
no lldp transmit
Syntax
Default
Command Mode
Usage Guideline
Example
Switch(config-if)# lldp transmit
Switch(config-if)# no lldp transmit
CLI Reference Guide
To enable the LLDP advertise (transmit) capability, use the lldp transmit
command in Interface Configuration mode. Use the no form of this command to
disable LLDP transmission.
This command has no arguments or keywords.
LLDP transmit is enabled on all supported interfaces.
Interface Configuration mode
This command is used to enable LLDP transmission on a physical interface.
When LLDP is not running (when the command no lldp run is issued on global
configuration mode), the router doesn't transmit LLDP message.
This example shows how to enable LLDP transmission.
This example shows how to disable LLDP transmission.
lldp transmit
384