Sflow Poller - D-Link DGS-6600-48T Cli Reference Manual

DGS-6604 m

sflow poller

sflow poller INSTANCE [receiver RECEIVER][ interval SECONDS]
no sflow poller [INSTANCE]
Syntax
INSTANCE
receiver RECEIVER
Interval SECONDS
Default
Command Mode
Usage Guideline
Example
switch(config-if)# sflow poller 1 receiver 1 interval 20
CLI Reference Guide
Use the sflow poller command to create/configure a Poller for the sFlow agent.
Use the no form of this command to delete one Poller or all Pollers.
The instance index if multiple Pollers are associated with one interface. The range
is from 1 to 65535.
The Receiver's INDEX for this Poller. If not specified, the value is 0. The
(Optional)
user can not configure the value to 0. The maximum number is project dependent.
The maximum number of seconds between successive polling samples.
(Optional)
The range is from 0 to 120. 0 means disable. If not specified, the default is 0.
No Poller is created.
Interface configuration mode.
The command is available for physical port interface configuration.
A Poller can only be configured on one interface. It cannot be associated with
multiple interfaces.
Use this command without keywords to create a default Poller or to reset an
existing Poller to default values. Use the no form of this command with
INSTANCE to delete one Poller. Use the no form of this command without
INSTANCE to delete all Pollers.
The user can only specify a Receiver that has its owner name setup. If the
Receiver associated with the Poller has its owner name is reset, the Poller will be
reset to the default setting.
Setting the polling interval to 0 disables the polling.An interface can be
configured with multiple Pollers.
This example shows how to create/configure the Poller of INSTANCE 1 with
RECEIVER as 1, and INTERVAL as 20 seconds.
sflow poller
556