Ipv6 Nd Suppress-Ra - D-Link DGS-6600-48T Cli Reference Manual

DGS-6604

ipv6 nd suppress-ra

ipv6 nd suppress-ra
no ipv6 nd suppress-ra
Syntax
Default
Command Mode
Usage Guideline
Example
Switch > enable
Switch # configure terminal
Switch (config) # interface vlan1
Switch (config-if) # ipv6 nd suppress-ra
CLI Reference Guide
This command is used to suppress IPv6 RA (router advertisement) on an
interface of this switch. Use the no ipv6 nd suppress-ra configuration command
to enable the sending of IPv6 router advertisements on an ISATAP tunnel
interface.
None
Suppress RA
(Sending of IPv6 router advertisements is disabled by default on an ISATAP
tunnel interface)
VLAN interface configuration
The VLAN interface must be created first before this command can be used.
ISATAP tunnel interfaces are valid for this command. Other types of tunnel
interfaces are invalid.
This example shows how to suppress IPv6 RA's:
ipv6 nd suppress-ra
339